The system currently works based upon the overall latency reported by the selected audio interface. This compensation will be in effect when recording from an External Input and with the Monitoring parameter turned Off.
ADDED “Re-pitch” engine mode to the Audio plug-in.For example, if your project tempo is 170 BPM and you load a loop which should be 174 BPM, MASCHINE will now set the Source Tempo as 174 BPM instead of 87 BPM as it did previously. The algorithm now chooses a tempo that’s closest to your current project tempo. IMPROVED Automatic tempo detection of the Audio plug-in.If the recording is complete, holding the footswitch down for a few moments will trigger Undo so you can try another take. If recording is in progress, pressing the footswitch once will stop the recording-double-pressing will abort the recording (any recorded audio to that point will be discarded). Pressing the footswitch again before recording has actually started will cancel the recording.
Pressing the footswitch will arm a recording according to the current settings. When in the Sampling page or when the Loop Recording mode is enabled on MASCHINE JAM, a connected footswitch can be used to control recording. Pressing MST will select MASCHINE’s Master output as the source (for resampling what is currently playing). Pressing GRP while in the Loop Recording mode will select the focused Group as the source. When pressing the IN 1 button, External Input 1 is selected as the source for the recording. Alternatively, pressing an empty Pattern button will trigger a recording and will then place that recording in a new Sound Slot AND a new Pattern will be created where only the new loop is playing back. While this new Loop Recording mode is active, pressing an existing Pattern will trigger a recording of a new loop which is then added as a new Sound in the existing Pattern doing this repeatedly allows you to quickly layer recordings on top of each other. Holding the IN 1 button enables this new Loop Recording mode (it’s also helpful to pin this mode on by holding IN 1 and pressing the SONG button). This feature automates the use of the new Target parameter for fast sampling and layering.
ADDED “Target” parameter to the Loop recording mode of the Sampling Page.
MASCHINE 2.7.4 および 2.7.5 がリリースされました。 Maschine 2.7.5 - Hotfix release.įIXED Re-pitch engine plays at the wrong speed when there is a sample rate mis-match between the Audio Interface and the audio file loaded in the Audio plug-in Maschine 2.7.4 - What’s New